Free workshop tool
Cut-List Optimizer
Your cut list, laid out on real stock boards: a cutting diagram per board, boards needed, and waste — with saw kerf as a number you can see and change. No sign-up, no email gate.
PlankBench — Cut-List Optimizer — plankbench.com
How the layout works
The tool uses shelf packing: pieces are sorted longest-side first, then placed row by row across the board. A piece goes into the first row it fits; when no row fits, a new row starts; when no row fits on the board, a new board starts. It is the same method a sawyer follows at the bench — which is the point: the diagram reads the way the cutting happens, left to right, row by row.
Kerf is charged honestly. The saw blade removes a strip of wood with every cut. The kerf input (default 1/8 in, the width of a common blade) is added between pieces and between rows — never at the board edges, where no cut is made. Set it to 0 only if you are laying out with a zero-clearance setup and want the geometry without it.
Rotation is your call. By default, pieces may rotate 90° when that fits them into a row — rotated pieces are drawn with a dashed outline and marked in the list. Uncheck the option when grain direction matters: a tabletop board with the grain running the wrong way is a worse outcome than an extra offcut.
Worked example — the default list
Two 40 × 6 in stiles and two 40 × 5 in rails, on a 96 × 12 in board, kerf 1/8 in:
Row 1: 40 + 1/8 + 40 = 80.13 in of 96 · Row 2: same, at 6.13 in down
Used: 880 sq in of 1,152 = 1 board, 23.6% waste
The waste is the offcut strip beside the second row and the kerf — visible in the diagram, not hidden in the number.
Limits, stated plainly
- Not optimal. Shelf packing is fast and readable, not mathematically optimal. A careful hand layout — or a true nesting optimizer — may fit the same list on fewer boards. Treat the board count as a planning figure, not a promise.
- Rectangles only. Curves, angles, and miters are not laid out. A piece with an angled cut should be entered at its bounding rectangle, and the angle cut afterwards.
- Length × width only. Thickness does not change the layout; all pieces are assumed to come from stock of the same thickness. For the board-foot tally and cost, use the board-foot calculator.
- Defects are not modeled. Knots, warps, and waney edges mean real boards yield less than the diagram. Inspect the stock and allow for it.
- Verify before buying. Confirm the stock sizes your supplier actually sells — a layout for a 96 × 12 in board is only useful if that board exists at your yard.
Questions, answered
What is 2D nesting, or a cutting diagram?
A cutting diagram lays out rectangular pieces on a stock board so you can see how many boards a cut list needs and where each piece goes. This tool uses shelf packing: pieces sorted longest-first, placed row by row.
Does the optimizer account for saw kerf?
Yes — kerf is a visible input (default 1/8 in) charged between pieces and between rows, never at the board edges. Set it to 0 to see the layout without kerf.
Is the layout optimal?
No. Shelf packing is fast and easy to follow at the saw, but a skilled sawyer rearranging by hand may beat it. Treat the board count as a planning figure and verify before buying.
Layout method and worked example last checked 18 November 2026. Found a mistake? Report it — corrections are logged on the changelog.