Free workshop tool

Deck Board Calculator

Deck size, board width, and gap in — boards needed, board feet, and cost out. Boards run along the deck’s length; rows are counted across its width, gap included.

Boards run this way
Rows counted across this
The width you buy — see note below
Between boards — 0 = tight together
Usually 1 in
Lengths you can buy
Leave blank for no cost
Board width: Board length:

Boards needed
21
21 rows × 1 board per row
Board feet / board
5.50
per board, from its size
Total board feet
115.50
boards × board feet each
Total cost
—
add a price per board foot to see cost

Your deck sizes are saved in this browser only — on this device, no account.

Deck layout

12.00 ft10.00 ft21 rows × 1 board per row

Schematic — one strip per row, drawn proportional to board width vs gap. Joints show where boards meet end to end.

Show your working — worked example

Worked example: a 12 ft × 10 ft deck

Boards 5.5 in wide, 1 in thick, 12 ft long, with a ¼ in gap.

Deck width in inches: 10 ft × 12 = 120 in
Rows across the width: 120 ÷ (5.5 + 0.25) = 120 ÷ 5.75 = 20.87 → 21 rows (always round up — a part-row still needs a board)
Boards per row: 12 ft deck ÷ 12 ft boards = 1
Boards needed: 21 × 1 = 21 boards
Board feet per board: (144 × 5.5 × 1) ÷ 144 = 5.5 board feet
Total: 21 × 5.5 = 115.5 board feet

That is the example pre-filled above. Change any size and the working updates.

Which width do you enter? Board feet here use the width you type. Deck boards are sold by nominal size but measure smaller dressed: a nominal 6 in deck board is 5.5 in wide. If your supplier tallies on nominal width, enter 6 instead of 5.5 — the tally follows the number you enter, so enter the one your supplier counts. Full table: nominal vs actual lumber sizes.

No waste allowance is added. Cuts, bad boards, and mistakes are real, but this page adds nothing silently. Round up or add boards yourself, so the number stays checkable. Always verify the final count against your supplier’s tally.

How it counts

Three steps, all visible. First, the deck width is converted to inches and divided by one board plus one gap — that gives the number of rows, rounded up, because a part-row still needs a full board. Second, the deck length is divided by the board length you can buy — that gives the boards end-to-end in each row, also rounded up. Third, boards times the board feet in one board gives the total. The board-feet formula is the same everywhere on this site: (length × width × thickness in inches) ÷ 144.

For individual boards of mixed sizes — a bench, a shelf, a bookcase — use the board-foot calculator, which holds a whole list. For the method behind pricing a project from a board-foot total, see how to price a project from board feet.

Worked example last checked 18 November 2026. See the changelog.